By Leon Sanger at June 24 2019 02:47:03
Draw a scaled plan using a pencil and graph paper. Now that the measurements have been taken it is time to get to work to create a scaled plan of the room. Drawing a room to scale on plan is simple once one understands that one quarter inch square on the graph paper equals one foot, and that inches can be estimated with half a square equaling 6_inches and a fourth of a square equating to 3_inches. Using the length and width measurements draw the basic room perimeter to scale onto the graph paper with a pencil. Draw in the doors, windows, etc. to scale on the graph paper in the same way you measured them in the room.
The façade is brick or wooden, with large windows. Ranch homes typically have an L_shaped hall which combines the living room and dining room into one area, with a hallway leading to the family room and a group of bedrooms all on one side of the house. A patio at the back with a glass sliding door leading to it is not unusual for a ranch house.
We are going to assume here that you have already looked into your financing options and have a good idea of the amount of your budget you can apply towards the actual building cost of your new home. Begin with this amount and deduct 10% right off the top. You will thank me for this advice in the end. Everyone goes over budget during construction, even the financial nerds can't control every little detail that comes along. Take this net building budget and divide this dollar amount by the average square foot cost to build you got from the realtor or builder. Since I hope they gave you a low and high range this will give you two new numbers. These numbers are the low to high total square footage house floor plans sizes you should be searching for. If you choose to look at multi_level house floor plans then you will be comfortable on the upper level of this number since your cost per foot will be lower.
Begin with measuring. Do a very rough drawing, on a piece of scrap paper for measuring purposes only, of your room showing walls and openings for doors, windows and fireplaces. Note where columns and built_in cabinetry are in the room as well. Take out the measuring tape and begin measuring a room writing down each measurement in the applicable space on your rough drawing. For a basic start, measure the length and width of your room.