By Michael Schmid at July 12 2019 10:05:06
It is also a good idea to keep a list of things that you don't like; things you may have seen in a magazine or noted when visiting other log homes. Some of the most frequent complaints one hears about log homes, especially older models, is the lack of storage space and small closets or bathrooms. This is most often the result of poor planning or not taking into consideration the diameter of log walls and the lack of attics in most log homes. Refer to your list when discussing details with your designer and remember that in most cases you cannot build a closet or a bathroom that is too large.
Technical difference _ In 2D floor plans, you, the designer, work on both y axis and x axis. Moreover, the design can be changed in up, down, right and left sides. On the other hand, 2D plans are a lot simpler and cheaper relatively. They can be used to show the right, top and front side of the object. Unlike 2D, designers work on three exis to create 3D floor plans. Actually, this is like molding an object that looks same no matter which angle you look at it from. With 3D technology, solid models and wireframes are created line by line.
Begin with measuring. Do a very rough drawing, on a piece of scrap paper for measuring purposes only, of your room showing walls and openings for doors, windows and fireplaces. Note where columns and built_in cabinetry are in the room as well. Take out the measuring tape and begin measuring a room writing down each measurement in the applicable space on your rough drawing. For a basic start, measure the length and width of your room.
The ranch floor plan is conventional and matter_of_fact. The roofs are low pitched with a large garage attached to the house. Ranch homes are single_storied. Split_level floor plans are not unusual.